Oricom DTX4200 UHF CB radio + BONUS ANU230 antenna

Posted February 25, 2019
Sale!

$499.00 $399.00

Openpay is available on orders from $500 - $1,500.

An Australian First!!
Oricom’s DTX4200 is like two radios in one, allowing you to ‘listen and receive two channels at the same time’, so that you can hear everything
that’s going on.

1 in stock

Description

Price Excludes Postage
Contact us in store to discuss Postage costs
(08)82410788

An Australian First!!
Oricom’s DTX4200 is like two radios in one, allowing you to ‘listen and receive two channels at the same time’, so that you can hear everything
that’s going on.

Heavy duty controller speaker microphone
Dual receive
IP54 dust and splash resistant
12/24 volt operation
3 memory groups of 16 channels per group
(PC programmable)
Large 96 multi-colour backlit display
Back light brightness (5 preset levels plus auto)
Fast scanning 80 channels within 3 seconds
Rotary volume/channel and squelch control
Duplex
38 CTCSS & 104 DCS codes
Auto power off (off/1h/2h/4h)
3.5mm external jack (for optional external
speaker or PA adaptor)
Included in the pack; 2m microphone extension
cable, slide in bracket, and mounting hardware
Requires UHF CB Antenna and mounting bracket (not supplied)
Heavy duty diecast metal chassis

DTX4200 TECHNICAL SPECIFICATION
GENERAL
Compliance AS/NZS 4365:2011
Frequency Range TX/RX 476.425 – 477.4125 MHz
Number of TX/RX Channels 80 UHF CB Channels (75 voice)
Channel Spacing TX/RX 12.5KHz
Operating modes Simplex, Repeater TX offset
(+750KHz)
Scanning Speed 50 msec per channel
Antenna Impedance 50 Ohms
Operating Volts nominal 13.8VDC to 28VDC
Operating Volts Range 10 to 30VDC
Over Voltage Protection Diode and Voltage
regulator system
Over Current Protection 2 AMP fuse
Reverse Polarity Protection Shunt diode
Frequency stability +/- 5 ppm
TRANSMITTER
RF Output Power 5 watts max
Modulation F3E(FM)
Maximum deviation 2.5KHz
Spurious Emissions < -30dBm TX Audio pre-emphasis +6dB/Octave from 300Hz to 3KHz Current consumption 1.7 AMP with 50 ohm during TX antenna termination RECEIVER Circuit Type Dual conversion super heterodyne Intermediate Frequencies 1st IF : 21.4MHz , 2nd IF : 450KHz for Main RX 1st IF : 38.85MHz, 2nd IF : 455KHz for Sub RX Receiver sensitivity -123dBm for 12dB SINAD Audio output power > 2 Watts at 8 ohm load
RX Audio de-emphasis +6dB/Octave from 300Hz
to 3KHz
Signal to Noise Ratio > 40dB
Conducted Spurious Emission > -57dBm
MECHANICAL
Dimensions (H) X (W) X (D) 31 X 128 X 147
Weight 548g transceiver

Quick Quote